Transducer Pole
SeeFish Transducer Mount 2.0
Here is our BRAND NEW arm design for the SeeFish Transducer Mount 2.0
We have come up with an ALL NEW design that allows for many more stowing options than before. We have done extensive testing an...
SeeFish Pole Wire Retaining Clip
NEW AND IMPROVED DESIGN!
These clips are made to house your LiveScope wires on our SeeFish pole without any sharp wear points on them. They come in packs of 3 or sold by themselves. They will clip ...
Pole Extension for SeeFish Transducer Pole
Adds 13" or 25" to the length of the SeeFish Transducer Pole to make the pole about 60"-61" or 72"-73" in total length.
**IF PURCHASING AFTER INITIAL POLE PURCHASE, YOU WILL NEED EXTENSION TAP AND ...
SeeFish Transducer Pole Extension Handle
This is an extension handle for our SeeFish Transducer Mount 2.0 Pole. It will extend handle from 12" to about 25".
SeeFish Quick Detach Mount
This is our NEW Quick Detach Plate and upright for our SeeFish Transducer Mount 2.0 . Your existing 2.0 arm will mount directly in this. This will allow you to remove the upright piece off of your ...
Angled End for SeeFish Transducer Mount 2.0
This is the angled end replacement if yours breaks. We are offering a full piece plastic if you lose the part that clamps around the pole as well. Just the plastic end cap and now a full machined a...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device